Midmark IQmark Digital ECG PDA Guia de Resolução de Problemas descarregar pdf (Página 34)

IQmark Diagnostic Workstation Operation Manual

Step 5. Once the network has been set up and the data source has been established at

each computer, double-click the IQmark Configuration icon and click the

Database Settings button.

Step 6. In the Database Settings dialog box, click Enable Network Database, so that

it is checked, then select Network under Default Database. Click the OK button

on the Database Settings dialog box and click OK on the IQmark Workstation

Configuration Settings dialog box.

Creating a Central Peer-to-Peer Database

 NOTE: The disk drive that will contain the central database must be configured

for full sharing on the network. Installing the IQmark Diagnostic

Workstation may require that you restart the computer.

If you have installed the IQmark Diagnostic Workstation on the computer designated as

the central database, then the database folders and files are already set up. Refer to

Software Installation earlier in this manual for complete instructions.

If you do not intend to install the IQmark Diagnostic Workstation on the central database

computer, then it is necessary to follow this procedure to set up the required folders and

files for the central database.

Step 1. Create the following folders on the central database computer:

\Brentwood\Database

\Brentwood\Database\Holter

Step 2. Copy the Workstation database file:

WorkstationDatabase.mdb

from one of the other computers (after the software is installed) to the central

database computer in the folder:

\Brentwood\Database

Back

Go To Table Of Contents

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 77 78

Sem comentários

Midmark IQmark Digital ECG PDA Guia de Resolução de Problemas Página 34